Size: 55x41x7mm, button not include
Weight: 23gVersion: Flysky, Frsky, JR (optional)Normal use operation in PPM mode:
1.Install RF Module in position, Set PPM signal output on you transmitter.
2.According to the default protocols table, turn protocol switch of RF module to choose the protocol.
3.After finish binding operation, Power on your transmitter, the red light of RF module will be on, then RF module is ready to work , after that power on your receiver (or craft).
Binding operation in PPM mode:
1.Power on your receiver, and set it to binding mode.
2.Hold and press the bind button of RF module, and then turn on your transmitter, after 2 seconds, release the button, you will see the red light flashing rapidly, then RF module is in binding mode, and the red light will go solid after binding.
3.Some protocols (eg: S-FHSS) don’t have binding procedure on RF module, and some protocols (eg: hubsan, e010)will auto bind when power up.Operation in Serial mode:
Turn the protocol switch to“0“ to access serial mode, in serial mode all available protocols are included. Transmitter that supports the er9X/erSky9X or OpenTX firmwares can work in this mode,